Aquacal AutoPilot SP05, Installation Manual

Page: 18 / 89

Page - 14
SunPower SP05 (Titanium / Cupronickel Exchanger Combination)
1.4.e In-Line Chlorine Feeders
Place in-line chlorinators downstream from the heat pump and as low in elevation as possible.
l
If an erosion type feeder is used, it is recommended that a Hartford Loop be installed to protect internal heat
pump components.
l
A Hartford Loop is not necessary with a Salt Chlorine Generator.
Heat Pump with Hartford Loop
1.4.f Water Flow Rates
Maintain water flow rates as indicated. Please note, these specifications relate to the heat pump only. Code-
specified whole system turnover rates must be satisfied.
NOTICE
Failure to heed the following may result in damage to equipment.
l
Water flow exceeding maximum flow rates will negatively affect the total pool filtration performance and may
damage the heat pump. This will not be covered under the equipment warranty.
Water Source
MODEL SOURCE HEAT EXCHANGER TYPE
FLOW RATES
MINIMUM MAXIMUM
WS03
Source-Side
Titanium ThermoLink
®
20 GPM (75.7 L/min) 70 GPM (265 L/min)
Cupronickel 10 GPM (37.9 L/min) 14 GPM (53 L/min)
Pool / Spa Titanium ThermoLink
®
30 GPM (113.6 L/min) 70 GPM (265 L/min)
1
-
Ins
ta
ll
at
ion