The diagram below shows the route of the cable
into the shower unit for connection to the terminal
blocks, connect as follows:
Earth cable to terminal marked
Neutral cable to terminal marked
Live cable to terminal marked
ELECTRICAL CONNECTIONS
Your Aquas Reva electric shower is provided with both Left and Right electrical connections to ease
installation particularly when replacing an existing unit
NOTE: ONLY ONE SET OF ELECTRICAL CONNECTIONS IS NECESSARY
EXAMPLE - RIGHT SIDE ELECTRICAL CONNECTIONS
The shower unit must be permanently connected
to the electricity supply, direct from the consumer
unit via a double pole linked switch with a
minimum contact gap of 3mm. The switch must
be readily accessible and clearly identifiable and
out of reach of a person using a fixed bath or
shower tray, unless the switch is cord operated.
The wiring must be connected to the switch
without the use of a plug or socket outlet.
The cable size required is determined by the kW
rating of the shower and the distance between
the shower and the consumer unit. The table
below will help you choose the correct cable for
your installation, but it will depend upon the
precise circumstances of the installation. If you
are in any doubt consult an electrician.
The incoming cable should be hidden.
IMPORTANT
Ensure that the terminal block screws are fully tightened and that no cable insulation is trapped under
screws. Ensure the cable clamp is used to secure the cable. The earth continuity conductor of the electrical
installation must be effectively connected to all exposed metal parts of other appliances and services in the
room in which the shower unit is installed to confirm.
