Aqua OC-105B, User Manual, Page: 6 / 17

SG-B SERIES STEAM GENERATOR
6 E005-28-10-12
5 Increase button
6 Decrease button
7 Dual function button switches a fan on and off also used to confirm
changes in temperature settings.
8 Time display
window
Display the resting and operating time of the steam generator
9 Temp display
window
Display the detected temperature of steam room
10 Light LED Indicator LED for the lamp of steam room .it is on/off with the on/off of
the lamp in steam room
11 Water LED Indicator LED for water level .red means water is filling. green means
water level arrived control point.note:if the LED always in red (exceed 5
minutes).check water supply and if water level valve is block .otherwise
the water level inlet valve will be broken .
12 Drain LED Indicator LED for draining – shows red for manual draining and green for
automatic draining at the end of the cycle.
13 Mode LED Shows red is for steam on demand mode and green for conventional
timing.
14 Heating LED Green indicates heating is on, red indicates the required temperature
has been reached and the heating has stopped
15 Overheat LED Indicator LED for over heat ,red means the steam generator was cut off
as the heat element is too hot (lack of water ,the heat elements may
worked in air)
16 Fan LED Indicator LED for Fan the lamp of steam room .it is on/off with the on/off
of the lamp in steam room
17 Clean LED Indicator LED shows descaling in operation.
Remarks : Please note for the generator to operate in steam on demand mode the steam on demand
button must be connected.
(3)
、
OC-S Steam on demand switch
The steam on demand switch can be located inside or outside of the steam room then connected to the
controller.
When the switch is operated the LED indicator inside the switch shows red and steam will be generated for
30 minutes. At the end of 30 minutes or if the switch is operated again, the light will go out and the steam
will stop.
(4)
、
commercial mode instruction(OC-B+OC-S )
If OC-B is under domestic model, only OC-B control the steam generator .OC-S doesn
’
t work. When
OC-B enter commercial model, The steam generator is under waiting status (the time window shows
“
Long
”
and on circuit board the LED is flashing) , press OC-S it will operate steam generator , every press
will make the steam generator keep on working for 30 minutes , the temperature control will rely on the
OC-B controller
’
s setting before enter commercial model