APV WD 40 M2, Original Operating Instructions

Page: 9 / 28

9
Quality
for
Professionals
5.7.1 5.7.1 5.7.1 5.7.1 D D D Displayed symobols and their meaning isplayed symobols and their meaning isplayed symobols and their meaning isplayed symobols and their meaning
Error message codes have been created to monitor the correct operation of the
device and inform the user when it is no longer operating properly.
Problem Problem Problem Problem Cause Cause Cause Cause Possible remedy Possible remedy Possible remedy Possible remedy
Digital display flashes Digital display flashes Digital display flashes Digital display flashes
Operating voltage under
12 Volt
- electricity supply directly from
the battery
- control cabling
- measure battery voltage (how
much volt the battery has)
- prepare a better voltage
supply
“b” battery error “b” battery error “b” battery error “b” battery error
flashes on the display.
flashes on the display. flashes on the display.
flashes on the display.
Slide valve is closed and
Slide valve is closed and Slide valve is closed and Slide valve is closed and
motor switches off.
motor switches off. motor switches off. motor switches off.
It is no longer possible to
It is no longer possible to It is no longer possible to It is no longer possible to
operate the devi
operate the devi operate the devi operate the device! ce! ce! ce!
Supply voltage too low or
fluctuations too severe Check the on-board electronics
and the battery.
Attention:
Attention: Attention:
Attention: If the battery is
charged by a charger in
operating mode "Start" then
this may result in voltage
peaks. This may damage the
device!
Disconnect the charger, check
the on-board electronics and
the battery.
“E” error flashes on the “E” error flashes on the “E” error flashes on the “E” error flashes on the
display
display display
display
Motor cable break
Check cabling and free
movement of scatter disc.
Motor jammed (=stiff)
Check cabling and free
movement of scatter disc.
6
6 6
6 Settings
Settings Settings
Settings
6.1
6.1 6.1
6.1 S
S S
Scatter
catter catter
catter width
width width
width
The scatter width is dependent on the density and shape of the scatter material and
the speed of the scatter disc. The seed spreader is designed to be able to evenly
spread scatter-material over an area of 12 m. For this to be successful, the battery
and generator must be in a good condition. Please see the scatter tables and point 13
for the precise settings for sowing volume, working width, etc. We recommend
attaching the scatter device 1 m above the ground or the crop to achieve an
acceptable scatter density.
Note:
Note: Note: Note: If the WD 40 M2 is fitted to machines with a small working width, and the seed
is to be scattered directly into/in front of the roller, the scatter device can even be
angled down slightly. However, please note that the tank will only be fully emptied if it
is level!