6
Quality
for
Professionals
5.2
5.2
5.2
5.2
Attaching to the tractor
Attaching to the tractor
Attaching to the tractor
Attaching to the tractor
For this type of attachment, screw
the tractor drawbar between your
WD 40 M2 and the supplied
counter plate. You should use
bolts with a diameter of 10mm.
Fasten the upper linkage of your
tractor into position with the bolt.
5.3
5.3
5.3
5.3
Fitting an attachment
Fitting an attachment
Fitting an attachment
Fitting an attachment
In order to extend the WD 40 M2 with an attachment,
the best way is to use the counter plate. Use this to
secure your WD 40 M2 to a frame on the
attachment.
Please ensure that the device is attached at a height of
approx. one metre above the crop or the ground.
5.4
5.4
5.4
5.4
Fastening the control module
Fastening the control module
Fastening the control module
Fastening the control module
Fasten the mount (supplied as standard) into the
cabin with two screws. Store extraneous cable in the
driver's cab to avoid trapping it.
TIP:
TIP:
TIP:
TIP: Pay attention to the angle at which you are
viewing the module to ensure optimum readability of
the display. You might have to slightly bend the
mount in order to set the best angle.
Pic: 1
Pic: 3
Pic: 2
Pic: 4
