8
Quality
for
Professionals
5.7
5.7
5.7
5.7
Control module
Control module
Control module
Control module
The small spreader is outfitted with a control module with a hermetically sealed
membrane keyboard. A two-pin plug
(for connection to the battery) and a four-pin
plug
(for connection of the scatter device to the control module) are located on the
underside.
The “On/Off” button, used to switch the device on and off, is at the
AA
bottom left.
The “-” and “+” buttons can be used to continuously regulate the speed of
the scatter disc.
Under these you can find the buttons to “close” and “open” the slide
valve.
The scatter disc starts to turn by actuating the “On/Off” button. The indicator lamp
then lights up above the button, indicating that the supply voltage is connected.
You can then control the speed of the scatter disc according to your requirements
using the “-” or “+” button.
If you then want to pull off and start scattering seed, you must use the “open slide
valve” button to open the slide valve; the indicator light for “slide valve open” above
the button lights up.
The scatter material then trickles onto the scatter disc and is spread in accordance
with the speed. When stopping, press the “close slide valve” button (indicator light for
“slide valve closed” above the button lights up) and the slide valve closes.
It only makes sense to switch off the motor as well when leaving the field.
Digital display
Lights up when
the spreader
is switched on
On/Off button
Increase/reduce
the speed
Lights up when the slide valve
is closed
Lights up when the slide valve
is open
Close and open slide valve
Pic: 7
