Apricot XEN Pentium 60, Owner'S Handbook Manual

Page: 92 / 139

XEN OWNER'S HANDBOOK 6/9
Using the SETUP utility
Chapter 6
Onboard Enabled or disabled.
IDE drive
First Serial Choices include disabled, or address 2E8H, 3E8H, 2F8H, or
Port Address 3F8H. If “Programming Option” has been set to auto, this
address will display “disabled.”
Warning
Do not select the 2E8H option. This may adversely affect the operation
of the on-board video.
Second Serial Select Disabled or address 2E8H, 3E8H, 2F8H, or 3F8H. If
Port Address “Programming Option” has been set to auto, this address will
display “disabled.”
Warning
Do not select the 2E8H option. This may adversely affect the operation
of the on-board video.
Parallel Port Select Disabled, or address 278H, 378H, or 3BCH. If
Address “Programming Option” has been set to auto, this address will
display “disabled.”
IRQ active High or low. The default is high.
State
Parallel Port Normal or extended. The default is normal. Extended enables
Mode the Enhanced Parallel Port (EPP), and Enhanced Capabilities
Port (ECP) features of the parallel port.
Configure with BIOS Defaults
This selection loads the default SETUP values from the ROM
table.
Configure with Power-on Defaults
This selection loads the power-on default values from the ROM
table.