Apricot XEN Pentium 60, Owner'S Handbook Manual

Page: 88 / 139

XEN OWNER'S HANDBOOK 6/5
Using the SETUP utility
Chapter 6
For drives of capacity greater than 528 Mbytes (e.g. the 1 Gbyte
drive shipped in XEN) this option should be set to Auto, and
the IDE LBA translation option in Advanced CMOS SETUP
must be enabled.
Drive C, D, Specifies for the time that the BIOS will spend interrogating the
E, F: timeout drive for IDE auto-configuration before displaying an error
message. The options are 0, 5, 15, or 31 seconds, default is 5
seconds.
If the default returns an error message try the 15 and 31 second
timeouts before resorting to manually entering drive type
information.
Keyboard The choices are installed or not installed. The default is installed.
Base Memory Reports the amount of base memory.
Extended Reports the amount of extended memory.
Memory
Advanced CMOS SETUP
Typematic This option is either enabled or disabled. The default is disabled.
Rate When enabled, the following two typematic options are valid.
Programming
1. Typematic Rate Delay (in milliseconds): choose 250,
500, 750, or 1000 millisecond delays. The default is
500. This determines how long it takes for the key-
repeat function to start when a key is held down.
2. Typematic Rate (in characters per second): choose 30,
24, 20, 15, 12, 10, 8, or 6 characters per second. The
default is 15. This determines the speed at which
characters repeat when a key is held down. The higher
the number, the faster the characters repeat.
Hit <F1> Choices are either enabled or disabled. The default is disabled.
Message If you enable this option, the message “Hit <F1> to Enter
Display SETUP” will appear on the screen during the power-up sequence.