35
8-1-2021
APQS.com
Lenni – Lucey Oparation
2.
Rollers will be placed in the following positions of the table legs.
3.
The labeled end of each roller mounts to the right table leg (the Leveler Bar does not have a specific direction for
installing). Place all of the Split Roller Collars near the LEFT side of the table (these are only installed on each
roller on the left side of the table).
4.
With the machine head on the left side of the table, insert the Pick Up Roller’s non labeled side into the machine’s
throat and rest the roller on the machine’s throat if necessary while you begin to install the shaft end. Move the
machine head toward the left table leg.
5.
Slide one Split Roller Collar onto the roller’s LEFT end.
6.
Move to the right side of your table and insert the Pick Up Roller’s labeled end into the uppermost hole on the
End Arm.
7.
“Center” the rollers between the two end arms, allowing about the same amount to extend past each arm.
Slide a Split Roller Collar onto the roller’s end. Leave a small amount of space between one collar and the end
arm as shown above (right) to leave room for the roller to rotate without binding. Tighten the 4 Collar Screws
with a 3/16” Allen Wrench.