Appro DVR-3064, Installation & Operation Manual

Page: 33 / 64

31
REC QUALITY:
This option determines the image quality to be
recorded. The DVR stores images in the
compressed format and allows the image quality
to be altered by the image size. There are 4 levels
of image quality you can select from:
BEST
,
HIGH, STANDARD,
and
BASIC
. Selecting the
BEST image for use provides higher-resolution
recorded images, and normally takes up more
storage space than a HIGH, STANDARD or
BASIC image does.
DISK FULL:
This option determines the way to utilize storage
media in case of a full disk.
REWRITE:
When the hard disk is full, the device
continues recording by displacing the old data.
STOP:
When the hard -disk is full, the device will
stop recording.
AUDIO:
This option determines the way to record sound if
necessary.
OFF:
Disables AUDIO recording.
11KHZ:
Enables AUDIO recording and records at
the 11KHz sampling rate.
22KHZ:
Enables AUDIO recording and records at
the 22KHz sampling rate.
NOTE: The audio function can only be activated in
the following refresh rates in NTSC(PAL): 30(25),
15(12.5), 10(8.3), 6(5),and 2.7(2.7) frames/sec.
POST-REC DURATION:
(Functional in “Pin connections with the
ignition key” only, refer to section 1.5.7)
After the ACC is powered off (ACC OFF), the
DVR will record continuously, obeying the time
which is set in the "
POST-REC DURATION
" time
until that time period is over. This option
determines the duration of the post-recording time
after the ACC is turned off. There are 9 options
here you can select from:
OFF
,
1 MIN
,
5 MIN
,
10
MIN
,
30 MIN
,
60 MIN
,
90 MIN
,
120 MIN
and
NON
STOP
.
OFF:
The recording will stop automatically when
the vehicle motor is turned off.
1 MIN:
There will be automatic recording for a
minute after the vehicle motor is switched off.
5 MIN:
There will be automatic recording for five
minutes after the vehicle motor is switched off.
10 MIN:
There will be automatic recording for ten
minutes after the vehicle motor is turned off.
30 MIN:
There will be automatic recording for
thirty minutes after the vehicle motor is turned off.
60MIN:
There will be automatic recording for one
hour after the vehicle motor is turned off.
90 MIN:
There will be automatic recording for 90
minutes after the vehicle motor is turned off.
120 MIN:
There will be automatic recording for
120 minutes after the vehicle motor is turned off.
NON-STOP:
This option allows for continuous
recording after a vehicle's motor has been
switched off. However, its functioning depends on
the amount of power the vehicle has available to it,
so it can run only as long as there is power.
Enough power will be left untapped by this option
to turn the vehicle motor on the next time the user
starts it.
Note: If the voltage is less than 10.4 volts, the
battery is in the "Too low" mode", and the DVR
will automatically power off and there will be a
problem in starting the engine in case of a
small – scale car.
SPLIT:
This option determines the layout of the screen. You
can select from
4CH
,
3CH
, and
2CH
. The resulting
layout on the screen will be as follows.
4 CH:
This option splits the screen in the quad
mode.
MENU SETUP
( continued )
CH1 CH2
CH3 CH4
01/01/2006 12:00:00