Appro DVR-3064, Installation & Operation Manual

Page: 39 / 64

37
SW : 1.21
DATE : Nov 10 2006
KEY : 1.00
REAR: 1.09
VERSION
DEFAULT:
This option allows you to reload the factory
default setting. Please do note that the
password cannot be changed in the factory
default setting.
SD SETUP:
The DVR offers a quick setup method by using an
SD card. If the user wants to set up a number of
the same devices with the same settings, he can
save the whole settings to an SD card, and then
transfer them to another DVR.
SAVE:
Saves the whole setting to the SD
card.
LOAD:
Loads the whole setting from the SD
card.
VERSION:
This item is in the setup menu: it shows the BIOS
version, the software version, the last updated
date, and the software version of the key board
and the rear board.
4.7 Notices of Alarm Setting
Before commencing with the alarm recording function,
please configure the recording setting properly
according to your needs. Take the following notices to
activate the programmed alarm recording.
ACC IGNITION ON:
During the processing (ACC ON), the DVR will start
the auto start recording function while powering on
(refer to section 4.1), and may be manually recorded
by the user (refer to section 3.2.1). To activate the
alarm recording, please set the “
ALM OPERATION
”
to “
ON
” in the “
ALARM SETTING
” page to enable the
function. When an alarm is triggered, the device will
record in the set alarm-recording rate.
ACC IGNITION OFF:
1.
After the ACC is powered off (ACC OFF), the DVR
will record continuously, obeying the time which is
set in the "
POST-REC DURATION
" time until that
time period is over.
2.
After the ACC is powered off (ACC OFF), any
externally triggered alarm will not influence the
recording mode which you set. But the DVR will
calculate the time of the "
POST-REC DURATION
"
anew in this situation.
3.
When the "
POST-REC DURATION
" time is over
while the “
DELAY OFF
” time is still going, the DVR
will not start the post-recording and the external
triggers will have no effect.