Unpacking
Preparation
Installation
Warranty
Operation
Appendix
Overview
REV-3.0 [3-17-11]
14
ComCenter-II ‘Outdoor’
Product Manual
The Ethernet Connection Mode can be changed via the connected POTS/
RJ-11 equipment. Listen to audible beeps to confirm the mode setting. To
change mode, take the POTS/RJ-11 phone off-hook and press the following
keys;
*610 = DIRECT (1 beep)
*611 = DHCP Client (2 beeps)
*612 = DHCP Server (3 beeps)
Additional useful commands using POTS/RJ-11;
Changing the Ethernet Connection Mode
Using POTS/RJ-11:
*994 gives audible beeps according to mode setting.
Accessing the embedded webpage in the ComCenter II may not be possible unless the default DHCP Client
mode is compatible with your specific network. Once you are able to access the ComCenter II’s webpage,
the mode can be changed by clicking on the CONFIGURE button. This page will allow you to change modes.
CAUTION: changing modes will likely cause you to lose access to the webpage until the network or direct
connection is also configured to this new mode.
Changing the Ethernet Connection Mode
Using Embedded Webpage:
Operation
