Apollo RoadRunner MRH16, Operating Manual

Page: 39 / 69

Mobile Digital Video Recorder
31
Select the desired box under the
Alarm-Out
heading, and a list of Alarm Outputs and Beep appear. Select the Alarm
Output connectors that you would like to activate whenever the DVR detects an input on the associated alarm input.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Select the desired box under the
Notify
heading, and the
Alarm-In Notify
menu appears.
You can toggle the entire list On and Off by selecting
Notification
. You can toggle
the individual items On and Off by selecting that item. Select
OK
to accept your
changes.
NOTE: For the Notify action, the notify item you select should be enabled in
the Notification setup screen and the DVR should be registered in the
RAS (Remote Administration System).
Select the desired box under the
PTZ
heading, and a list of PTZ presets appear. Select the preset position for each PTZ
camera, where you want PTZ cameras to move to whenever the DVR detects an input on the associated alarm input.
Motion Detection
PATH: Event menu > Motion Detection > Settings tab
Your DVR has built-in video motion detection. Video motion
detection can be turned On or Off for each camera.
Figure 43 — Motion Detection Settings screen.
Selecting the box under the
Sensitivity
heading allows you to adjust the DVR’s
sensitivity to motion for Daytime and Nighttime independently. There are five settings
with
1
being the least sensitive and
5
being the most sensitive.
You can define the area of the image where you want to detect motion; e.g., a doorway. Select the box under the
Zone
heading, and the
Motion Detection Zone
screen displays.
The
Motion Detection Zone
screen is laid over the video for the selected
camera. You can set up motion detection zones by selecting or clearing
blocks.
NOTE: Blocks can be selected by holding down the mouse button and
dragging the pointer to where you want to end the zone, and
individual blocks are selected or cleared by clicking the mouse
button.