34
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Certificate:
70118144
Project:
70191110
Master Contract:
237484
Date Issued:
2018-08-14
DQD 507 Rev. 2016-02-18
Page 3
UL 60079-0: 2013
Standard for Safety – Explosive Atmospheres – Part 0: Equipment
– General Requirements, Ed. 6
UL 60079-11:2014
Standard for Safety – Explosive Atmospheres – Part 11:
Equipment Protection by Intrinsic Safety “I”, Ed. 6
MARKINGS
The manufacturer is required to apply the following markings:
•
Products shall be marked with the markings specified by the particular product standard.
•
Products certified for Canada shall have all Caution and Warning markings in both English and French.
Additional bilingual markings not covered by the product standard(s) may be required by the Authorities Having
Jurisdiction. It is the responsibility of the manufacturer to provide and apply these additional markings, where
applicable, in accordance with the requirements of those authorities.
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US (indicating that products have been manufactured to the requirements of both Canadian and U.S. Standards) or
with adjacent indicator 'US' for US only or without either indicator for Canada only.
Nameplate adhesive label material approval information:
CSA-Accepted (Class 7922-01, File number 99316) adhesive label stock Product Number 7871 manufactured by
3M, which is suitable for indoor or outdoor use on Plastic Group VII at a maximum service temperature of 80C or
higher. The label stock is printed with one of the approved printer and ink combinations as specified in the
manufacturers listing and the finished label is affixed to the housing.
The Sensor is marked with the following details on the marking:
1. Manufacturer’s name or registered trade mark;
2. Model Number as in the PRODUCTS section, above;
3. Serial number S/N XXXXXX;
4. Entity Parameters as in drawing 9005002;
5. Ambient Temperature Rating: as specified in the PRODUCTS section above;
6. DC Power Symbol 1, Table 1, IEC 61010-1
7. Hazardous Location Designation: As specified in PRODUCTS section above;
8. On nameplate: ”Install per DWG# 9005002”.
9. The CSA Mark with “C” and “US” indicators, as shown on the Certificate of Conformity.
