ApenGroup Aermax Series, Use, Installation And Maintenance Manual

Page: 12 / 60

12
code HC0100.00GB ed.A-1509
HY
AQUAPUMP HYBRID
HYBRID HEATER
2.6. Power supply
The equipment must be correctly connected to an effective
earthing system, made in compliance with current regulations
(IEC 64-8).
Cautions
•
With the help of qualified personnel, check the efficiency
of the earthing system;
• Check that the mains power supply is the same as the
power input stated on the equipment nameplate and in
this manual;
• Do not mistake the neutral for the live wire. The equipment
can be connected to the mains power supply with a plug-
socket only if the latter does not allow live and neutral to
be swapped;
•
The electrical system and, more specifically, the cable
section, must be suitable for the equipment maximum
power input, shown on the nameplate and in this manual;
• The electric cables must be kept away from heat sources.
I
MPORTANT: an omnipolar switch having fuses with
contact opening greater than 3mm must be installed
upstream of the power cable. The switch must be visible,
accessible and positioned at a distance lower than 3 metres
from the equipment. All electrical operations (installation
and maintenance) must be carried out by qualified staff.
2.7. Use
Do not allow children or inexperienced people to use any
electrically powered equipment.
The following instructions must be followed:
•
do not touch the equipment with wet or damp parts of your
body and/or with bare feet;
• do not use the gas pipes to earth electrical equipment;
• do not touch the hot parts of the equipment, such as the
fume exhaust duct;
• do not place any object over the equipment;
• do not touch the moving parts of the equipment.
2.8. Maintenance
Before carrying out any cleaning and maintenance operations,
isolate the heater from the mains power supply using the switch
located on the electrical system and/or on the shut-out devices.
If the equipment is faulty and/or incorrectly operating, switch it
off and do not attempt to repair it yourself, but contact our local
Technical Service Centre.
All repairs must be carried out by using genuine spare parts.
Failure to comply with the above instructions could compromise
the safety of the equipment and invalidate the warranty.
If the equipment is not used for long periods, shut the gas
supply off through the gas stopcock and disconnect it from the
power supply.
I
f the heater is to be put out of service, in addition to the
above operations, potential sources of hazard on the unit
must be disabled.
W
arning: in order to ensure the correct
operation of the equipment, preventing
its damage or problems for persons, it is
mandatory to add a percentage of glycol to
the filling water, proportional to the minimum
winter temperature of the area where the
boiler is installed.
I
t is strictly FORBIDDEN to connect a system
filling circuit to the waterworks mains
.
For its machines, APEN GROUP tested and recommends
to use
ALPHI 11
glycol by Fernox; the following KITS
contain packs with different capacity:
code
capacity
C07200-05 5 litres
C07200-25 25 litres
Warnings for glycol use
In case of direct intake of high doses, the
product may cause effects on the central
nervous system, respiratory diseases and
kidney damage. Avoid contact with skin and
eyes – protect the respiratory tract.
Do not allow the product to enter sewers,
surface water and groundwater, ground.
Use gloves, rubber boots and normal tight
working clothing. Wear tight goggles.
For further information, refer to the safety
data sheet of
Cookson Electronics, Alpha Metals S.p.A.,
Via Ghisalba 1, 20021 Bollate, Milano, Italy
Tel: +39.02.383311 Fax: +39.02.38300398
e-mail: fernox_italy@cooksonelectronics.
com www.fernox.com