Automatikprodukter
Ozone Detector c/w
Indicator for Temperature/Humidity
O3TH
Dec.11
We reserve the right to make changes and improvements in our
products which may effect the accuracy of the information contained
in this leaflet.
Important information
1.
Always cut off power before mounting, removing and
cleaning the monitor.
2.
Read all of the information in this datasheet before
mounting the detector.
3.
Notice the supply power voltage of the transmitter:
24Vac/dc.
Do not install the transmitter on voltages higher than
marked on the transmitter
Mounting and Wire Connection
1.
Cut off power first. Simualtaneously depress the 2
clips on either of the sides of the detector gently with
your nails or other unsharp tools, then move off the
face part.
2.
Mount the detector on the place where you want to
detect O3 level 0,3m above floor.
Do not behind a door, in a corner, in direct sunlight and
near any heat or steam sources.
Do not mount the detector in the direction of the outlet
of the Ozone generator or in places where wind pass
through.
3.
Mount the wall plate first.
Place the detector against the wall at desired
location;
make sure wires can be passed through the
holes of the wall plate.
4.
Connect wires to terminal strips, (see the label
attached on the wall plate and fig.3).
Make sure wiring connection correct and scure.
5.
Cover the face part to the wall plate