12
5.If replacing the belt, remove the
engine bolts with a 5mm hex
wrench. Slide the engine slightly
out of the frame, so there is
enough space to remove / replace
the belt in the gear. Replace the
spacers and retighten the feet.
6.Install the spare wheel into the
frame and slide the belt back onto
the pulley. Do not tighten the axle
nuts yet. Install lever braking
equipment – do not adjust yet.
FIG.13
FIG.14
FIG.15
FIG.16
7.Ensure the adjusting washers are
correctly positioned against the
frame. After tightening the axle
nuts with a 13mm wrench, check
the alignment of the wheels and
the tread of the belt by turning the
wheel in the opposite direction by
hand. You may need to adjust the
washers to align the belt. Refer to
the instructions on page 10 to
tighten the belt.
8.Retighten the brake arm bolt with
a Phillips screwdriver and 8mm
wrench.
Summary of Contents for AIYAPLAY AA1-106V70
Page 37: ...37 ...