Model
50L31
Document No.
ITCT0223
Version
v5.0
Panel
V500HJ1-LE1 Rev.Cx
Effective from
2013-9-10
Date Updated
2013-9-10
NO
Amount
Diagram
Tool Parameters
1
1
Processed base assembly
Picture of actual
item
Electric screwdriver
2
7B11-041696-20105111
4
Picture of actual
item
7
±
1kgfcm
3
4
5
Prepared by
Reviewed by Approved by
Zhang Wei
Ф
4
×
16mm B-head black-zinc-plated machine screw
with spring washer
Fit base assembly to the bottom of base.
Fasten base assembly to the bottom of machine with 4PCS screws.
Station Name
Base Installation
Section/Serial No. Unit Assembly 23
Operations and Requirements
Set up machine and power on.
When finished, step on the switch with foot and send the product to
next station.
Project Controlled Seal
Notice
2. Install screws by the serial number (install one by one) and abnormalities such as screws being neglected, tilted and slipped are not allowed.
3. When uprighting machine, keep the machine on the middle of table.
Figure:
Recent
Modification
Record
1. Wastes produced by this station shall be placed in the assigned position. Refer to
Waste Classification and Disposal List
.
Part Number
Descriptions
Please read and understand the
operating instructions carefully
Take only
one screw
at a time
23
Process Requirements:
1. Check for rusted screws, missing
slots or bad cross slot.
2. Check if the electric screwdriver
torque force is within the specified
requirements.
3.When installing screws, align the
electric screwdriver and the screw to
the screw hole vertically (do not tilt).
4. In the process of installing screws,
properly exert pressure to make a close
contact between electric screwdriver
and screw slot to avoid slipped screw.
5. Put the defective screws in the
defective product box and do not
throw them at will.
Specific subject in
accordance with work order
Summary of Contents for LE50H264
Page 27: ...Operation Instructions ...
