Model
50L31
Document No.
ITCT0205
Version
v5.0
Panel
V500HJ1-LE1 Rev.Cx
Effective from
2013-9-10
Date Updated
2013-9-10
NO
Amount
Diagram
Tool Parameters
1
6149-110303-12112303
1
Figure 1
2
3
9015-112L31-61034031
1
Figure 2
4
6149-510063-517U1203
1
510mm dual-terminal LVDS
5
Prepared by
Reviewed by Approved by
Zhang Wei
1100/600mm three-terminal 8pin,5pin(lack
3pin),4pin wire main board to key board/remote
control receive board
Take 1PCS three-terminal connecting wire and 1PCS remote control
receive board, then insert 5PIN end of connecting wire to remote
control receive board. Check if it is inserted in place.
32-42L31 remote control receive board assembly
(blue) A5version
Notice
Section/Serial No. Unit Assembly 05
Part Number
Descriptions
Operations and Requirements
Station Name
Remote Control Receive Board Installation
1. Wastes produced by this station shall be placed in the assigned position. Refer to
Waste Classification and Disposal List
.
2. Fit remote control receive board in place, fit it entirely into the slot of surface frame.
Fit the remote control receive board to surface frame as illustrated, and
make sure remote control receive board is fit in the slot completely.
Figure:
Insert LVDS wire to horizontal socket on panel.
When finished, step on the switch with foot and send the product to
next station.
Project Controlled Seal
Recent
Modification
Record
Please read and understand the
operating instructions carefully
5
Insert panel end
of LVDS here.
First align the plug of data cable to the interface of
socket, then press it slightly to insert into the socket
firmly, and then pull it back gently to check if it is
inserted firmly; if not, press the elastic snaps at both
sides of plug with thumb and forefinger and take
out the data cable, and then reinsert LVDS wire
properly.
Figure 1
Figure 2
Summary of Contents for LE50H264
Page 27: ...Operation Instructions ...
