11
P/N 1010807 Rev. Q 09/18
®
Problem
Possible Cause
Corrective Action
Product is over toasted,
Platen heat is too high, or
drop time is too slow.
Temperature set too high.
Set temperature control to a lower setting.
Bun Thickness Compression Knobs
set improperly.
Measure bun thickness and set Bun Thickness Compression
Knobs correctly (Figure 7).
Buns sticking on Release Sheet.
Clean or replace Release Sheet according to the procedure in the
Maintenance section of this manual.
Conveyor Cover Assembly not
installed properly.
Re-install Conveyor Cover Assembly.
Loose sprocket setscrews.
Check drive chain for kinks, broken or bent links, or other
damage. Check motor sprocket and drive sprockets; tighten
setscrew on flat of shaft if required. Check for damaged/worn
sprocket and replace as required.
Conveyor Belt Chain too loose.
Adjust Conveyor Belt Chain length as described in the
Maintenance section of this manual.
Spring Tensioner Assembly or Roller
Tensioner is damaged or missing.
Replace Spring Tensioner Assembly or Roller Tensioner if
damaged or missing.
Product is under toasted,
Platen heat is too low, or
drop time is too fast.
Bun Thickness Compression Knobs
set improperly.
Measure bun thickness and set Bun Thickness Compression
Knobs correctly (Figure 7).
Wiring problem.
Contact your maintenance person or Authorized Service Agency
for service.
Inoperable Thermostat.
Conveyor Drive Motor inoperable or
incorrect conveyor motor installed
in toaster.
Product is getting stuck or
Conveyor Belt Chains stop
when product is toasting.
Bun Thickness Compression Knobs
Set improperly.
Measure bun thickness and set Bun Thickness Compression
Knobs correctly.
Release Sheet not cleaned properly
or is missing.
Clean or replace Release Sheet as described in the Maintenance
section of this manual..
Conveyor Drive motor inoperative or
incorrect conveyor motor installed
in toaster.
Contact your maintenance person or Authorized Service Agency
for service.
Conveyor Drive Chain loose, worn,
or broken. Loose motor drive
sprocket.
Check drive chain for kinks, broken or bent links, or other
damage. Check motor sprocket and drive sprockets, tighten
setscrew on flat of shaft if required. Check for damaged/worn
sprockets and replace as required.
Conveyor Belt Chain too loose.
Adjust Conveyor Belt Chain length as described in the
Maintenance section of this manual.
Spring Tensioner Assembly or Roller
Tensioner is damaged or missing.
Replace Spring Tensioner Assembly or Roller Tensioner if
damaged or missing.