22
www.antiktech.com
Gigabit Output
Under multiple output operation mode, user can set output uni/multicast IP addresses and port number for
each encoder, the built-in remux, and ASI input. Each IP output channel can be switched ON/OFF
independently. The source for TS/IP output 1-8 is forced to link to the encoder 1-8 respectively and cannot be
changed. The source for the 9
th
uni/multicast output channel can be the built-in remux or ASI input.
(Note: the page below is displayed only when the TS/IP operation mode is Multiple Output mode. To change
the TS/IP operation mode, please refer to
chapter 8.5 System-Device
.)
Gigabit Input
Under Multiple output mode, the Gigabit Input is not available.
Local Settings
Set the parameters for the TS/IP output port.
Gigabit Address:
set the IP address of the IP port
Gigabit Subnet Mask:
set the net mask of the IP port
Gigabit MAC Address:
display the MAC address of the IP port, cannot be modified by user
Gigabit Gateway:
set the gateway address under which the IP port is connected
Gateway MAC Address:
set the MAC address of the gateway under which the device is connected, this is
necessary when the IP streaming is needed to pass through the gateways
Full-duplex Output Mode
The pages below are displayed under Full-duplex mode. To change the TS/IP operation mode, please refer to
chapter 8.5 System-Device
.