Anthos SMART TOUCH R7, Operating Instruction

Page: 43 / 90

43 43 EN
R7
- OPERATING INSTRUCTION
5.5. Micromotor
Coupling the handpieces and changing the chuck.
Refer to the specific instructions furnished with the micromotor and various
handpieces.
Use.
WARNING!
Also read the instructions for use of the various motors.
The instrument is supplied non-sterile.
• Operating time: work 5 min., rest 5 min.
• The cock ( f ) adjusts the water flow to the spray.
• The cock ( e ) adjusts the amount of air spray for all the instruments.
• Place the instrument in its work position.
NOTE: instrument activation is indicated by the relative manage-
ment page appearing on the TOUCH DISPLAY.
• The main icon buttons available on the TOUCH DISPLAY are the following:
Settable value increase
Settable value decrease
Reduction ratio selection
Reduction ratio selection
Speed change mode selection
Micromotor rotation direction selection
Fibre optics on/off
Independent water supply selection/deselection
(only with S.H.S./S system)
Fibre optic brightness adjustment.
• To adjust the fibre optic brightness, touch and hold (for at least 2 seconds)
the icon button .
• Adjust the brightness by touching the icon buttons or .
NOTE: the settable value ranges from 1 to 16.
• To confirm the brightness selected, exit this submenu by touching the
icon button .
NOTE: after 30 seconds of not using the instrument (foot control
lever deactivated), the fibre optics turns off.
Instrument spray type enable and selection
Row of general operating icons
(see paragraph 5.1.)
Micromotor operating mode
selection ( only with i-MMs micromotor ).
Micromotor operating program
selection
• Use the foot control pedal to start the instrument (see paragraph 5.2).