Anthony Lifgtates, Inc.
18
MRT Models
www.anthonyliftgates.com
800-482-0003
4.8 Installation Procedure
This section of the manual will guide you through
the complete installation process, step-by-step. It is
important that you follow all of the instructions in the
sequence we have provided. This sequence will provide
a quicker and easier installation process of the liftgate.
SAFETY
INSTRUCTIONS
Even though the Anthony liftgate is easy to
install, the installation should be done with at
least two people.
4.8.1 Tack Weld Liftgate Assembly To Truck
Body
1. Make sure the proper required bumper (ICC or
REAR UNDERRIDE) is in place and meets all Federal
Regulations.
2. Cut the banding attaching the hoses and wiring to the
liftgate.
3. Measure and determine the centerline of the liftgate.
Mark this point.
4. Measure and determine the centerline of the truck’s
rear sill. Mark this point.
WARNING
ROLLOVER HAZARD
Failure to prevent the truck from
moving during the installation of
the liftgate could result in serious
personal injury or crushing of the
installer(s).
5. Use a forklift or hoist to raise the liftgate onto the rear
of the vehicle. Lay hoses and wires down to the side
of the liftgate where they will not be damaged.
Tip: Raise the liftgate by the top shipping support,
located between the columns.
