Antaira Technologies - Industrial Ethernet Switches
LNX-0500-M12-67 Series User Manual V1.0
9
3.2 Wall Mounting
Follow the steps below to mount the industrial Ethernet switch to a wall using the screw holes as
shown below in
Figure 3.3
.
1. Prepare 2 screws for mounting the switch to a wall.
NOTE
: Recommended to use the M3 or M4 screws.
2. Based on the positions of the 2 screw holes on the top and bottom side of the switch, make 2
screw holes on a wall accordingly.
3. Insert the screws through the screw holes on the switch and screw the switch into the wall.
4. To remove the switch from the wall, do the opposite from the steps above.
NOTE
: Make sure to disconnect
all cables from the switch before removing the
unit from the wall.
Figure 3.2
Install the Ethernet Switch on the DIN-Rail
