Anslut 416-108, User Instructions

Page: 193 / 214

EN
193
Before starting
1� When the installation is finished, the water pipes connected and the system bled and checked for
leakage, the appliance can be started�
2� Start the appliance by pressing the ON/OFF button on the control panel�
3� Check that the control unit shows normal values and that there is no abnormal vibration or noise�
4� If the appliance runs without any problems for 10 minutes this first check can be considered to be
completed� If not, see the section on service and maintenance�
5� While the appliance is running, check that the inlet water temperature is the same as what is
shown on the control unit� If the water is not being heated properly, see the section on trou-
bleshooting�
IMPORTANT: We recommend that the appliance is not run in heating mode or hot water mode with an
ambient temperature of over 32°C – risk of activating the safety functions�
USE
Wired control unit
Status light ON/OFF
ON/OFF button
Selector for control according
to water temperature/room
temperature
Night reduction
Keypad
Signal receiver
Display
Button for mode selection
Timer controlled defrosting
Keypad cover
Temperature
UP button (temperature)
DOWN button (temperature)
UP button (parameters
and time)
DOWN button (parame-
ters and time)
Timer ON
Timer OPFF