Anritsu BTS Master MT8221B, User Manual

Page: 105 / 362

Error Messages B-3 Operation Error Messages
BTS Master UG PN: 10580-00207 Rev. E B-5
Lock failed during initialization
One or more of the Phase Lock Loops failed to achieve lock status during startup. Insure that
the battery level is adequate for operation or that temperature is within acceptable limits.
Reset to factory defaults with either Factory Defaults, ESC+ON, or MASTER RESET,
ON. Caution: Use of MASTER RESET, ON, will erase all user saved setups
and measurement traces and return the unit to a fully Factory Default condition. If the error
persists, contact your Anritsu Service Center.
Reference LVL Cal is OFF
Factory Calibration is OFF. Insure that the battery level is adequate for operation or that the
temperature is within acceptable limits. Reset to factory defaults with either Factory
Defaults, ESC+ON, or MASTER RESET, ON. Caution: Use of MASTER RESET,
ON, will erase all user saved setups and measurement traces and return the unit to
a fully Factory Default condition. If the error persists, contact your Anritsu Service Center.
IF Cal is OFF
Factory Calibration is OFF. Insure that the battery level is adequate for operation or that the
temperature is within acceptable limits. Reset to factory defaults with either Factory
Defaults, ESC+ON, or MASTER RESET, ON. Caution: Use of MASTER RESET,
ON, will erase all user saved setups and measurement traces and return the unit to
a fully Factory Default condition. If the error persists, contact your Anritsu Service Center.
Cannot set Delta Mkr Freq to Demod Freq
Marker to Demod frequency is only available with a primary marker as the selected marker.
Fan Failure
The system has determined that the fan should be running due to the internal temperature of
the unit, but cannot detect that the fan is actually running.
It is important to keep the fan inlet and exhaust ports clear of obstructions. The cooling fan
will vary the speed in relation to the internal temperature of the instrument. The fan will
turn on at low speed when the internal temperature of the instrument reaches 44
º
C, and will
increase the fan speed to maximum at 54
º
C. As the internal temperature of the instrument
decreases, the fan will reduce speed until the temperature reaches 39
º
C, at which point the
fan will turn off.
Figure B-1. Fan Speed versus Temperature
FAN
SPEED
OFF LOW HIGH
H
I T
E
M
P W
A
R
N
IN
G
A
U
TO
S
H
U
T
O
FF
Temperature Rising
FAN
SPEED
OFF LOW HIGH
Temperature Falling
TEMP
39
41 43 45 47
49 51 53
-100 85
90
+100
o
C
40 42 44 46
48 50 52 54