Anova TC102, Instruction And User'S Manual

Page: 15 / 30

8
5. INSTRUCTIONS FOR USE
5.1 SAFETY RECOMMENDATIONS
DANGER The machine must only be used for the purpose for which it was designed (cutting
and collecting grass).
Do not tamper with or remove the safety devices installed on the machine. REMEMBER THAT THE
USER IS ALWAYS RESPONSIBLE FOR DAMAGE AND INJURIES TO OTHERS.
Before using the machine:- read the general safety regulations, paying special attention to driving and
cutting on slopes;- read the instructions for use carefully, make sure you are familiar with the controls
and know how to stop the blades and the motor quickly;- never put your hands or feet next to or under
rotating parts and always keep away from the outlet.
Do not use the machine when you are in poor health or under the influence of medication or any other
substance that may reduce your reflex actions and your ability to concentrate.
It is the responsibility of the user to assess the potential risk of the area where the work is to be carried
out and take all necessary precautions to ensure their own safety and that of others, especially on
slopes or uneven, slippery and unstable terrain.
Do not leave the machine on tall grass with the engine running to avoid the risk of starting a fire.
CAVEAT This machine should not be used on slopes greater than 10° (17%). If the machine is likely to
be used primarily on sloping ground (never more than 10°), place the counterweights under
the front wheel support. These improve stability at the front end and reduce the chances of
tipping over.
IMPORTANT : All references related to the positions of the controls are described in chapter
4.
5.2 IMPORTANCE OF CUTTING SAFETY DEVICES
Safety devices work in two ways: - They prevent the engine from starting if all the safety requirements
are not met - They stop the engine if only one of the safety requirements is missing.
a) To start the engine, it is necessary that:- the transmission is in "neutral";- the blades are not
activated;
- the operator is seated and the parking brake is applied.
b) The engine stops when the operator leaves his seat.
NOTE
The blades will stop when the machine goes in reverse, pressing it towards «R». Press
the button (to the right of the seat on the rear cover) to make the blades rotate.
5.3 INSTRUCTIONS BEFORE STARTING WORK
Before you start mowing, it is necessary to carry out several checks and operations to ensure that you
can work efficiently and in maximum safety.
5.3.1 Seat adjustment
To change the position of the seat, loosen the four fixing screws and slide it along
the slots. Once you have found the correct position, tighten the four screws.
5.3.2 Tire pressure Having the correct tire pressure is the main condition to ensure
that the mower deck is horizontal and can cut evenly. Unscrew the valve caps and