annke SANNCE N43SU, Quick Start Manual, Page: 14 / 32

9
Steps:
1. Connect NVR and IP camera into the same router respectively by using the network cable, make sure they are
in the same LAN (It connects to the router through wifi if it is a wifi IP camera, not through the Ethernet cable).
2. Connect NVR to the monitor.
Method 1: Right-click the mouse will pop up the quick menu, click “ Quick Set ” enters into the interface of mode
selection to add the IP camera, then tick and click “ Add ” the channel you want to add the IP camera, click
“ Apply ” to save the setting.
Method 2: Right-click the mouse will pop up the quick menu, click “ Guide ”> “ Time-Language
Configuration ”> “ Network Test ”> “ Install Mobile App ”> “ Add Devices ”> “ Mode Selection ” enters into the
interface of mode selection to add the IP camera. There are three modes: Quick set , Auto-connected mode ,
Manual mode , as shown in the figure below.
Please select “
Quick set
” or “
Auto-connected mode
”, and click “
Next
” enters into the interface of adding the IP
camera, then tick and click “
Add
” the channel you want to add the IP camera, click “
Next
” and “
OK
” to save the