Quick Installation Guide
Option 1 Repeater Mode Installation
If this is not your first time setting up this device, we recommend that you first reset to
start anew, and then follow the steps below. Please refer to the
FAQ Question 7
for
reset instructions.
If you would like to set up your Anker device in Repeater mode with the Wi-Fi
Protected Setup (WPS) security option, note that WPS may not support all systems
and may result in network conflicts. To move forward and set up Repeater mode with
WPS, please skip directly to
FAQ Question 9
for more details.
We suggest you set your router to a static wireless channel for long term use. If
there are many wireless networks in range and your setting is on “Auto,” the
channel may switch often, causing disconnection. We recommend channels 1, 6,
and 11.From your router's configuration page, your channel settings can typically
be found under the "wireless settings" menu option.
Please verify that your router or modem is working properly and that your existing
devices can connect to the Internet successfully.
Select your desired mode
After reading the different solutions described above, if you decide to choose
Repeater
mode, please adjust the three-way switch button on the side panel of
your Anker device to
Repeater
.
Select the device location
Identify the wall socket where you would like to place the Anker device. Ensure
Step 1. Set your router a static wireless channel and confirm Live Internet
Connection
Step 2. Install the Device
Step 1. Confirm Live Internet Connection
Step 2. Install your Anker Device
Step 3. Connect Computer to your Anker Device Wirelessly
Step 4. Configure your Anker Device
Step 5. Connect to the Wireless Web
1.1
1.2
2.1
2.2
3
