Anest Iwata E-M10C Series, Instruction Manual

Page: 60 / 73

- 16 -
3) Inspect output of electrostatic controller (E-SC12 (-FM) series)
CAUTION
(1) Never contact No.5 terminal (pin), connector case or other terminal with test bar of tester. If done, it can
damage circuit since excessive current flows in electrostatic controller.
(2) Pay attention to the range of tester. If not, it can damage tester and electrostatic controller.
① Measure output voltage between electrostatic controller connector No. 5 terminal and
electrostatic controller ground terminal
◎
Normal voltage
＝
In the range of DC11.5
〜
12.5V
◎
Measuring condition
：
Set voltage at -40kV(MAX), remove low voltage cable from electrostatic
controller, keep electric source of electrostatic controller ON and then measure use tester to
measure voltage.
Normal voltage DC 11.5 〜 12.5V
EBC-12S7
Connect to ground
Tester