Anest Iwata E-M10C Series, Instruction Manual

Page: 42 / 73

④
Wrong operation
Avoidance of wrong use
Never point toward human or animal during spraying. If done, it can cause inflammation of eye
or skin and bodily injury.
Never use gas other than compressed air. If done, it can cause fire or poisoning accident.
Never use at higher than max. operating pressure (refer to specifications on page 2).
Avoidance of wrong operation
Before inspecting, cleaning, disassembling or assembling electrostatic spray gun, be sure to
turn off electric source of electrostatic controller (E-SC12(-FM) series: option), interlocked
equipment and equipment and fully release air and fluid pressure in the following procedure.
If not, it can cause bodily injury by wrong operation.
Job 1) Turn off electric source of electrostatic controller (E-SC12(-FM) series: option) .
Job 2) Stop supply of compressed air, paint and solvent to spray equipment.
Job 3) Turn electrostatic spray gun downwards, pull trigger, operate fluid needle and fully
release air pressure and fluid pressure.
Bodily protection
Protection from high voltage
The Model E-M10C for low resistance paints and water based paints, must be used with an
Approved/Listed paint supply isolation/voltage block system rated for -40kV in order to
provide operator protection from electric shock.
Be sure to ground voltage block system. If not, it can cause bodily injury by electrostatic
accident or electric shock since high voltage is charging voltage block system.
*) Refer to instruction manual of Voltage block system or Paint supply isolation system.
When insulating and using paint, fluid hose and paint supply unit (electrostatic spray gun:
E-M10C series + insulation stand) and touching electrostatic spray gun, paint supply unit or
metal in painting site in order to clean and inspect painting equipment, be sure to turn off
electric source of electrostatic controller and operate while ground wire or ground bar
(grounded metallic bar) comes into contact with painting equipment.
If not, electric shock can cause bodily accident if charging is not turned off or ground is not
connected, since high voltage is used.
◎
operating order
Turn off charging of electrostatic controller and electric source.
In 10 seconds, make ground wire or ground bar contact with metal which operator touches
during operation.
Operate while ground wire or ground bar comes into contact with metal.
Approved
Voltage block system
or
Paint supply isolation system