AIRSLIM [L]
24
6.2
Power Connections
The Anemoi AIRSLIM [L] fan motor has three connectors that must be connected to the control board. In the figure
of section 6.1 you can see where to connect the cables directly to connectors 5, 6 and 7.
The Anemoi AIRSLIM [L] fan control board must be connected to an electrical voltage of 110VAC - 240VAC I, 50 /
60Hz. These cables are connected to connector 1 of the figure in section 6.1. The labels L1/N, L2/F, L3 , and GND
can be read on the plate.
•
Connections for 220-240 VAC I electrical voltage
GND
L1
L2
L3
•
Connections for 120 VAC I electrical voltage
GND
L1
L2
L3
It is possible to use both shielded and unshielded cables, with a maximum section of 4mm².
The electrical cables must be arranged in a separate circuit from the control cables to avoid interference.
WARNING!
Do NOT use wires with worn or damaged insulation.
Doing so may result in serious or fatal electrical shock,
fire or other accidents.
Ensure that the wires are held securely and protected from abrasion, chaffing, overload or other
damage
. Risk of serious or fatal electrical shock, fire or other accidents.
Do NOT connect the motor to the input line directly.
Failure to do so may result in equipment damage.
Connect the ground line (GND) first.
Failure to do so may result in equipment damage.
Input Line
220-240 VAC
GND
N
F
Input Line
120 VAC
GND
F1
F2
