Anderson RBM Series, Operator'S Manual

Page: 79 / 87

Anderson Group Self-Loading Trailer – Operator's Manual 79
7.6.7 Replacing the wheel bearings
NOTE: For axles with grease retainers (see Figure 35), you will need to get new
grease retainers, since they will be damaged in the process of removing the
outer races.
NOTE: Unpack the bearings at the last minute and be careful to avoid mixing up
their parts.
To replace the wheel bearings:
1. Remove the wheel bearings as described in "Lubricating the wheel bearings" on page 76.
2. Remove the outer races of the bearings, which are inside the hub (see Figure 38).
NOTE: Note the positions of the outer races and grease retainers for
reassembly.
NOTE: If the axle has grease retainers, they will come out at the same time
as the outer races and will be have been damaged as a result.
3. Insert the outer races as shown in Figure 39.
NOTE: Make sure to put the outer races and grease retainers in the correct
positions.
NOTE: If the axle has a grease retainer, first put the retainer in its housing
(in the correct direction). Make sure it is centred and remains in place
throughout the process of putting the outer race back in.
4. Perform a final check.