Anderson RBM Series, Operator'S Manual

Page: 46 / 87

46 Operator's Manual – Self-Loading Trailer Anderson Group
4.7 Adjusting the bale retaining support
The retaining support prevents the bales from falling on the loading arm during the loading process.
It must be adjusted to the diameter of the bales being loaded.
To adjust the retaining support based on the diameter of the bales (see Table 12):
1. Remove the quick-release pins (A) that hold the auxiliary support in place (B).
2. Raise the auxiliary support.
3. Put the pins back in to secure the auxiliary support.
4. If needed, loosen the screw knobs (C).
5. Slide the retaining support all the way out so it is fully extended.
6. Tighten the screw knobs to hold the support in place.
Ensure that the inner fork of the arm has been
adjusted to the diameter of the bales being loaded
(see "Adjusting the forks" on page 41). If the fork
is not adjusted properly, it could collide with the
support.
Figure 16 — Adjusting the Bale Retaining Support