Safety instructions
10
Edition 02.19
qTOWER
3
84 / qTOWER
3
84 G
2.5
Safety instructions, transport and installation
Observe the following:
Only transport the device in its original packaging and with the transport lock in
place! Make sure that the device is empty and no sample vessels are in the
sample block.
Please verify that the delivery is complete on receipt of the qTOWER³ 84 and
check for possible transport damage. If the delivery is incomplete or the device
was damaged during transport, please contact Analytik Jena AG.
To prevent health damage the following must be observed when moving the
device in the laboratory (lifting and carrying):
−
For reasons of safety 2 persons are required to transport the device and
must position themselves on both sides of the equipment.
−
Since the device does not have handles, grip the device firmly with both
hands at the lower end, lifting it simultaneously.
The guide values and statutory limits for lifting and carrying loads without
auxiliary equipment must be observed and adhered to.
The qTOWER³ 84 can be installed by the Analytik Jena AG customer service or trained
specialist personnel authorized by Analytik Jena AG.
2.6
Safety instructions - operation
2.6.1
General
The operator of the qTOWER³ 84 must make sure before each commissioning that the
condition of the device including the safety equipment is sound.
Observe the following:
Free access to the power switch on the back of the enclosure has to be ensured
during operation.
The ventilation fittings at the rear of the device must be unobstructed and op-
erational. Covered vents or ventilation slits etc. may cause the device to break
down or may cause damage to it.
Be careful to avoid crushing or pinching injuries when closing the device.
