NATIX™
PAGE 16
Chapter 3 : OPERATING MODE
3-1. OPERATING WITH THE REMOTE CONTROL SOFTWARE
Your NATIX
™
is shipped with a WINDOWS 95 or later compatible software. This software allows you to control and
make adjustments by a simple mouse click.
3-1-1. SOFTWARE INSTALLATION
c
Turn your computer ON and wait for Windows to completely start.
d
Insert the disk into the floppy drive.
e
In the Windows
START
menu, click on RUN.
f
Choose the disk drive and click on
setup.exe
(ex: A:\
setup.exe
if disk 3.5" is drive A).
g
Follow the Windows installation instructions.
3-1-2. COMMUNICATION SETUP
•
CASE OF RS-232 PORT:
c
Connect the RS-232 cable between the
NATIX
™
and the control device according to your installation, as
indicating in the section 2-2-1.
d
Then only power ON all of the devices.
e
Click on the program files
iX8022
in
Start > program >ANALOGWAY > iX8022
to run the software.
f
Click on
Controls
menu and select
RS232/LAN setup
, then:
- With the
Controls
menu of the software, select
RS232/LAN setup,
then select the
COM
port number
corresponding to the connection of the
NATIX
™
device.
Figure 13
If the communication is OK, the message
"
Device connected
" is displayed.
