35
BACKREST RECLINE
TIP LIMIT SWITCH
When equipped with a power tilt and power or manual recline
combination, your power wheelchair will include a tip switch
located on the right-hand side inside the backrest shroud. The
purpose of the tip switch is to control the total angle of the tilt and
recline combined.
This tip switch can be manually adjusted to change the total tilt/
recline angle to a desired or comfortable level for the user. This
total tilt/recline angle should never exceed the horizontal plane
(180°). Technicians must watch for the tilt actuator inside the base
shroud as it can reduce the
total tilt/recline angle limit.
The total tilt/recline angle
should stop before the
backrest shroud touches
the base shroud.
Tip limit
switch
SEAT ELEVATE
DRIVING IN REDUCED SPEED (CREEP MODE)
Reduced drive speed is a feature designed to allow the user to
drive the wheelchair at a reduced speed while lifted up to 11”
(280 mm). When elevated, the drive speed is then reduced to
25% of its original speed. Full drive speed is achieved when the
seat elevate is down to its lowest position.
!
DANGER
Never operate the seat elevate when the power wheelchair is
on a slope. In creep mode, the wheelchair must be driven on
a level surface. If the seat is elevated and the reduced speed
does not slow the wheelchair’s drive speed to 25% of its original
settings, have it or the power seat elevate system serviced by an
authorized supplier or qualified technician.
Summary of Contents for ALLTRACK M3
Page 51: ...51...