25
CANTILEVER ARMREST ADJUSTMENT
(Fig.4)
The cantilever armrests can be flipped-back, are height
adjustable, but they are not removable.
CANTILEVER ARMREST ADJUSTMENT
(FIG.4)
a) To adjust, remove the two bolts (E) behind the armrest
with 2
7
/
16
” wrench.
b) Reposition in the available holes for desired height.
c) Retighten bolts (E) on each side.
!
WARNING
Reinstall bolts and tighten them securely.
Fig.4
E
NOTE
-
For proper seat and back adjustments, technicians must refer
to the
Adjusting Seat, Back and Center of Gravity Instruction
Guide
on on our website:
https://amylior.com/instruction-guides/
MULTI-AXIS HEADREST
(Fig.4-5)
The multi-axis headrest has a pivot ball at the bottom to allow
up to 3” (75 mm) of lateral movement. The kit is supplied with
additional hardware consisting of nuts and bolts to replace the
quick latch system if desired. It also comes with a second vertical
bar that can add another 2” (50 mm) of movement in
all directions.
NOTE
- When pushing the quick latch back in, it should be hard and
stiff to close down. It should leave a pressure mark on your palm.
If it still moves after that, repeat by tightening the nut, not the latch.
The first time it is tightened, usually the star washer on the inside will
”break” the paint. The second time, it will be firmly set into the metal
and hold well.
If it is still not tight enough, you can use the replacement nuts and
bolts supplied with every headrest to lock it into place.
Fig.4
Quick latch
u
Pivot ball
u
t
Straight height
adjustment rod
t
Tightening nut
Fig.5
2” (50 mm)
curved height
adjustment rod
u
p
Nuts and bolts
replace quick
release hardware
Summary of Contents for ALLTRACK M3
Page 51: ...51...