AMX TDS, Operation/Reference Manual

Page: 41 / 106

AMX TDS - Terrestrial/Satellite (Standard Definition)
33 AMX TDS (Television Delivery System)
Connecting an IR Emitter
1.
Connect an IR01 IR Emitter cable ( FG-IR01 ) to the IR Tx port on the DTV Receiver.
2.
Run the other end of the IRTX cable to the display device and locate the IR window.
3.
Attach the IR Emitter bud over the device’s IR sensor by removing the cover of the reverse side of the
Emitter and sticking it directly over the IR window.
Rear Panel - Reset Pushbutton
Press to the Reset Pushbutton on the rear panel to reboot the Receiver (FIG. 47).
Rear Panel - Status LEDs
There are three LEDs on the rear panel to indicate various types of device status (FIG. 48):

Power ( red ): Lights to indicate that the Receiver is receiving power (via PoE), and is functional.

Streaming ( yellow ): Flashes to indicate that the Receiver is receiving or sending data from or to the
master.

Lock ( green ): Lights to indicate that the Receiver is locked to a transport stream, and should be
playing video/audio (if valid channel is selected).
Rear Panel - Audio Output Connectors
The Audio Output connectors are grouped under "AUDIO" on the rear panel (FIG. 49):

Analog
: Standard red and white AUDIO RCA connectors provide analog stereo audio output
(White = Left, Red = Right).

Digital : The Black SPDIF RCA connector provides digital audio output.
FIG. 47 Reset Pushbutton
Reset Pushbutton
The RESET pushbutton is used in conjunction with the recessed Factory Reset
button on the front panel to perform a full factory reset of the Receiver. See the
Performing a Full Factory Reset on the DTV-RX01-SD Receiver
section on page 35
for details.
FIG. 48 Status LEDs
FIG. 49 Audio Output Connectors
Power
Streaming
Lock
RCA Stereo cable
Digital Stereo cable