![background image](http://html1.mh-extra.com/html/amx/pro-dp16-decor-prolink-flush-mount-keypad-panel/pro-dp16-decor-prolink-flush-mount-keypad-panel_instruction-manual_2937903024.webp)
Panel Programming/Operation
20
PRO-DP16 Decor 16-Button PROlink Wall Panel
Programming Defined Presets
The number of Presets available to program depends on the setting of DIP switch 7.
If DIP switch 7 is set to Off (Default mode), pushbuttons 1-10 are available as Preset buttons, and
pushbuttons 11-16 are used for other panel functions (i.e. Clear, Off, Select, Up/Down, and Mode
selection.
If DIP switch 7 is set to On (Preset Recall mode), all pushbuttons (1-16) are available as Preset
buttons. Refer to the
DIP Switch Configuration
section on page 15 for details.
1.
Ramp all active channels to 0 using the
Select
(pushbutton 13) and
Up/Down
buttons
(pushbuttons 14 and 15). Alternatively, you can use the
Off
button to turn all lights off.
2.
Press
Select
to choose a channel/zone.
3.
Press the
Up/Down
buttons to ramp the light to the desired level. The length of time that you
hold the button down determines the ramp speed.
4.
Press the Up/Down arrows simultaneously for approximately two seconds to enter the
Program Mode
(PGM). When the PGM LED indicator lights, the Program Mode is active.
!
If DIP switch 7 and 8 are On, the programming feature is disabled and the panel buttons
can only be used to recall Presets. Push buttons 1-16. The corresponding recall Preset is
based on the Preset Offset settings.
!
If DIP switch 7 is On and switch 8 if Off, the programming and recall Preset features are
enabled. Push buttons 1 - 16 and the corresponding Preset is recalled. Simultaneously
press the Up/Down arrows and enter the Record Preset Mode. The Preset recall is based
on the Preset Offset settings.
If you make a mistake, or decide not to change Presets, press the Up and Down arrows again to
cancel the Programming Mode.
5.
Press a Preset button. The selected Preset LED remains On after it is programmed with a Preset
light level.
6.
Repeat the preceding steps as required for other Presets.
Programming Ramping Presets
1.
To enter Ramping Preset mode, press and hold the desired Preset button for 2 seconds.
Ramping Preset mode is indicated by the Up/Down button LEDs (lit simultaneously).
2.
Press the
Up
and
Down
buttons (pushbuttons 14 and 15) to ramp the light level for the selected
Preset as needed.
3.
Release the Preset button to stop ramping. Preset Ramping mode quits after 6 seconds.
4.
Repeat the preceding steps as required for other Presets.
Summary of Contents for PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL
