AMX PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL, Instruction Manual, Page: 28 / 30

Panel Programming/Operation
24
PRO-DP16 Decor 16-Button PROlink Wall Panel
7.
The panel automatically exits Low-End mode.
Panel Operation
The following sub-sections describe using the panel to recall, adjust, and ramp programmed
presets. These instructions assume that the panel has already been programmed.
Recalling a programmed Preset
To recall a programmed Preset, simply press the Preset button associated with the Preset. The LED
next to the selected button lights to indicate the active Preset.
! If the panel is in Preset Recall mode (DIP switch 7 set to On), any pushbutton (1-16) can
recall a Preset.
! If the panel is in Default mode (DIP switch 7 set to Off), pushbuttons 1-10 can recall
Presets. In Default mode, the Select (pushbutton 13), and Up/Down (pushbuttons 14 and
15) buttons do not recall Presets, and Off (pushbutton 12) recalls the Off Preset.
For more information on Preset Recall and Default modes for the panel, refer to the DIP Switch
Configuration section on page 15.
Ramping Presets
Ramping a Preset involves either raising or lowering a light level on an active Preset. DIP switch 7
determines if the panel has the ability to raise or lower channel levels.
!
If switch 7 is in default mode (Off), pushbuttons 14 and 15 function as Up and Down
buttons for ramping presets.
!
If switch 7 is On, channel ramping is disabled, and pushbuttons 14 and 15 recall Presets
(instead of ramping channels).
To raise and lower the light level for Preset in a selected zone (0-100%):
1.
Press Select until the desired channel/zone LED is active (indicated by the channel LED).
2.
Press and hold the Preset for approximately 2 seconds to activate the desired lighting level that
you want to ramp.
3.
Press the Up/Down buttons (pushbuttons 14 and 15) to raise or lower the light level for the
selected channel/zone.
4.
Continue selecting zones and repeat steps 1 through 3 as many times as needed.