AMX PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL, Instruction Manual, Page: 19 / 30

DIP Switch Configuration
15
PRO-DP16 Decor 16-Button PROlink Wall Panel
DIP Switch Configuration
This section describes the functionality associated with the various DIP switch settings available on
the PRO-DP16 panel. These switches determine the front panel functions and should not be thought
of as user accessible.
DIP Switch Functions (1-8)
The panel functions are set by the configuration of the DIP switch (FIG. 7), located on the back of
PRO-DP16 panel. The factory default is for all the switches to be in the Off position. Note the
orientation of the DIP switch (upside-down, relative the front panel), and remember that the arrow
printed on the DIP switch points to the On position.
The factory default is for all of the switches to be shipped in the Off position, as shown in FIG. 7.
The following table lists the operational assignments for the PRO-DP16 DIP switch.
Always disconnect the PROlink cable from the PRO-DP16 to remove power before
changing DIP switch settings. Once the switche(s) are set, reconnect the PROlink
cable to the PRO-DP16 to provide power to the panel.
On power-up, the pushbutton LEDs momentarily light in sequence until the Channel 1
LED remains on.
FIG. 7 PRO-DP16 DIP switch, located on the rear panel
DIP Switch Assignments
Switch On Off (factory default)
1 Bit 1 Preset Offset. Offsets panel pushbuttons by 4.
With this offset, the pushbuttons = 5-20.
Default - no offset (pushbuttons = 1-16)
2 Bit 2 Preset Offset. Offsets panel pushbuttons by 8.
With this offset, the pushbuttons = 9-24.
Default - no offset (pushbuttons = 1-16)
3 Bit 3 Preset Offset. Offsets panel pushbuttons by 16.
With this offset, the pushbuttons = 17-32.
Default - no offset (pushbuttons = 1-16)
4 N/A N/A
5 N/A N/A
6 Off = Preset 64+ offset Off = Preset 12+ offset (default)
7 Preset Recall mode: recalls Presets on pushbuttons
1-16. Default mode: recalls presets on pushbuttons
1-10; enables ramp level up/down on Up/Down
buttons (pushbuttons 14 and 15).
8 Program/record disable Program/record enable (default).