Battery Removal and Replacement
21
Battery Replacement & Firmware Upgrade - 5.2” Modero ViewPoint Touch Panels
MVP-5100/MVP-5150 Battery Removal and Installation
After the latest firmware has been installed and the battery fully discharged, the battery may now be removed
from within the device. A Phillips-head screwdriver is necessary to complete the removal and the new battery
installation.
Removing the Old Battery From the MVP-5100 or MVP-5150
1.
Before starting, remove the battery and back cover from their packaging, and inspect the assembly for any
damage or distortion.
2.
Place the device face-down on a surface that will not scratch the unit and remove the five screws from the
back cover (FIG. 5).
Two of the screws are at the upper corners of the device, underneath rubber feet that also act as
screw covers. Remove the rubber feet to access the screws.
Remove the lower rubber foot to reach the remaining three screws.
3.
Discharge all static electricity that may have built up on your body, either by using a static discharge strap
or by touching a nearby piece of metal.
Do NOT discharge the battery before installing the latest MVP-5100/5150 firmware
(v2.66.21 or later), available at
www.amx.com
. Prior to battery removal, run the
device until the battery is completely discharged.
If the battery and back cover shows evidence of damage, contact AMX for
replacement and proper disposal information.
FIG. 5
Screw placement at the back cover of the MVP-5100
Upper screws
Lower screws
IR emitter panel
(underneath rubber foot)
(underneath rubber feet)
Serial number
label
Summary of Contents for Modero Viewpoint MVP-5200i
Page 4: ......