Displaying Stream Content
67
MAX-CSE/MAX-CSD10 Operation/Reference Guide
12.
Enter a numeric value into the
Target Port
field. This field corresponds to the port on the destination
device to which the outgoing video (
audio/video
) stream is being directed.
It is recommended that this value not currently be used by another port on the target device.
It is recommended that the following ports also not be used: 21, 22, 23, 80, 443, and 1319.
For the purposes of these procedures, we’ve chosen to use
5000
as the video Target Port.
13.
If using RTP as a Transport Protocol, enter a value into the
Target Audio Port
field. This field
corresponds to the port on the destination device where the audio only portion of the stream is being
directed to.
This value cannot match the value entered into the
Target Port
field above.
If using
UDP as a Transport Protocol, this field becomes greyed-out and unused since the both the audio and
video content is being combined into a single stream.
For the purposes of these procedures, we are not required to enter a Target Audio Port value
because the A/V content is not begin streamed separately.
14.
Click the
Apply
button to save the encoding profiles to the MAX-CSE.
Configuring the MAX-CSE audio/video inputs
1.
Complete the MAX-CSE connection and wiring procedures outlined within the
Wiring the MAX-
CSE connectors and cables
section on page 12.
2.
Access the A/V Setup page (FIG. 43) by clicking the
Audio/Video
button in the Navigation Bar.
This page provides the user with the ability to select the source of the incoming video signal (from
either the rear Composite or S-Video port), the format of the incoming video (NTSC/PAL), and the
gain given to the incoming audio signal.
3.
From within the Video section of this page, check off the appropriate Video In and Video Port radio
boxes which correspond to both the type of video signal being used and its associated format.
For the purpose of these procedures, we’ve chosen to feed an NTSC signal into the rear
Composite video connector. As a result, a user should "check-off"/select both the
Composite
and
NTSC
radio boxes.
If using RTP, both the Target Port and Target Audio Port
must be different and
should use even numbers
.
FIG. 43
A/V Setup page
Summary of Contents for MAX-CSD 10
