MAX-CSD10 Video Decoder
6
MAX-CSE/MAX-CSD10 Operation/Reference Guide
The following table outlines the specifications for the MAX-CSD10 Video Decoder.
MAX-CSD10 (FG2178-72) Specifications
Dimensions (HWD):
1.58" x 5.54" x 6.95" (4.01 cm x 14.07 cm x 17.65 cm)
Power Requirements:
• 500mA @ 12VDC (6W)
• Power Over Ethernet (
POE
) is available.
• Optional 12VDC power input overrides
POE
when used.
• Power requirements are usage dependant.
• This product is intended to be supplied by a Listed external power supply
rated from 10 to 18 VDC, minimum 500 mA or equivalent.
Weight:
2.02 lbs (0.92 kg)
Enclosure:
Metal with black matte finish
Certifications:
FCC Part 15 Class B, CE, and UL listed
Video Outputs:
Composite Video (via BNC)
S-Video (via standard female S-Video connector)
Audio Outputs:
Analog Stereo (RCA connectors - Red/White)
Supported Resolutions:
• NTSC (480i)
• PAL (576i)
Supported Video Codecs:
• MPEG2 (2 Mbps - 6 Mbps)
• MPEG4 (500Kbps - 3 Mbps)
Supported Audio Codecs:
• MPEG Audio Level 2 (MP2)
• MPEG Audio Level 3 (MP3)
• AAC
Front Panel Components:
• ID Pushbutton:
Used to both set the NetLinx ID (
Device only
) assignment and reset the unit
back to its factory defaults.
• Status LED:
Green LED blinks to indicate both the system and communication status with
the target Master.
• LCD Display:
Provides system information such as the currently used IP Address.
• IR Receiver:
• Receives 38KHz AMX IR codes.
Rear Panel Connectors:
• S-VIDEO OUT:
Mini-Din4 port for composite S-Video output.
• ETHERNET 10/100:
Single RJ-45 port provides 10/100 Mbps network communication and
POE
.
LEDs show communication activity, connections, speeds, and mode informa-
tion.
• AUDIO R/L:
Two RCA connectors (Red and White) support line-level stereo output for ana-
log stereo signals.
• 12VDC PWR:
Single 2-pin 3.5mm mini-Phoenix (male) captive-wire connector from an
optional 12 VDC power supply (
overrides
POE
).
• COMPOSITE OUT:
Composite Video Output (NTSC or PAL) via a female BNC connector.
• IR/Serial:
Single 2-pin 3.5mm mini-Phoenix (male) captive-wire connector is used for IR/
Serial control output by generating IR with the use of an IR emitter (
while in IR
mode
).
This port can support high-frequency carriers of up to 1.142 MHz and can also
generate IR with no carrier frequency.
Summary of Contents for MAX-CSD 10
