AMX IRLIB, Instruction Manual

Page: 16 / 38

12 IRLIB Menus and Options IRLIB Infrared Library Management Program
−
The left-most part is a columns used to build a list of functions that will
are used to program an Panja IR device. The middle section of the table
will list the Hand Control library files available from the current data di-
rectory. Captured functions of the selected Hand Control will be listed
in the right-most column.
•
Print Prints the function description list showing the functions selected for
programming Panja IR devices.
•
Load Reads functions stored in Panja IR devices and identifies them in the
currently selected DCU function description list.
•
Program Sends the list of DCU function descriptions to Panja IR devices
for storage in the permanent memory. Memory contents are cleared first
then reprogrammed.
•
Memory Checks the amount of memory remaining in an Panja IR device.
Provides a measure of the storage space left for additional Hand Control
functions.
•
Verify Compares a DCU function description list to the stored contents of
an Panja IR device. Used to check the results of a PROGRAM operation.
•
Actuate Activates IR output of a programmed IR device for testing and
diagnostic purposes. The Device number and Function number are entered
to activate the mechanism being tested.
•
Save File Saves a custom file as a DOS file but not a hand control (.IRL)
file. An example would be a Custom.SAV file. Refer to the Saving a Custom
File subsection for more information on custom files.
•
Load File Loads and retrieves a custom file. You use this command to
open a custom file in IRLIBX.
•
Memory Test Performs a memory test verifying the hardware function-
ality of an AXC-IR/S IR or Wired Serial card. This test is valid for AXC-IR/S
cards only.