AMX Enova AVX-400, Operation/Reference Manual, Page: 16 / 50

Wiring and Device Connections
8 AVX-400 Enova Twisted Pair Presentation Switcher Operation/Reference Guide
AXLINK
All AVX-400 units have an AxLink port and adjacent status LED (FIG. 10). This port allows the unit to be controlled
from any AxLink Master such as a NetLinx NI Controller. A green LED shows AxLink data activity. When the AxLink
port is operating normally, blink patterns include:

Off - No power, or the controller is not functioning properly.

1 blink per second - Normal operation.

3 blinks per second - AxLink bus error. Check all AxLink bus connections.
To use the 4-pin 3.5 mm mini-Phoenix (female) captive-wire connector for data communication and power transfer, the
incoming PWR and GND cable from the 12 VDC-compliant power supply must be connected to the AxLink cable
connector going to the Integrated Controller. FIG. 11 shows the wiring diagram. Always use a local power supply to
power the Integrated Controller unit.
Make sure to connect only the GND wire on the AxLink/PWR connector when using a separate 12 VDC power supply.
Do not connect the PWR wire to the AxLink connector’s PWR (+) opening.
’
FIG. 10 AxLink Port
The AVX-400 cannot be powered by this port or use the port to power other devices.
FIG. 11 4-pin mini-Phoenix connector wiring diagram (using external power source)
Top view
Top view
NI Master AVX-400
Local 12+ VDC
power supply
(coming from an
external
power supply)
When you connect an external power supply, do not connect the wire from the PWR
terminal (coming from the external device) to the PWR terminal on the Phoenix
connector attached to the Controller unit. Make sure to connect
only the AXM, AXP,
and GND wires to the Controller’s Phoenix connector when using an external power
supply.
If the Master does not recognize that the AVX-400 is online again after you reboot the
AVX-400, re-seat the AxLink connection or reset the Master.