AMX AVB-RX-DGX-SC Fiber-DVI, Instruction Manual

Page: 47 / 79

Scaling Options
43 DGX Transmitters & Receivers Instruction Manual
10.
Click Save* to store the currently displayed settings (if the settings have been changed since
clicking Apply, the newest settings will be saved) on the RX and persist them in memory. (The RX
will power up in the Manual option.)
* If you click Close instead of Save immediately after applying settings, the utility asks if you want to
save prior to exiting. Selecting Yes applies the settings, persists them on the RX, persists the Manual
mode on the RX over power cycles, and closes the utility. Selecting No closes the utility; the applied
settings are still in effect and can be accessed under the Manual option. However, they are not stored on
the RX and on power cycle, the RX will revert to its previously stored settings.
Retrieving, Saving, and Loading Settings
Time Saving Tip:
When a number of RX modules are connected to destination devices of the same
type, the menu options can be used to retrieve the settings from one RX, save those settings to a
file, and then load the settings to another RX.
Note:
When retrieving or loading a timing, the program will automatically display “Custom” as the
selected Resolution Source and “Advanced” as the selected Timing Mode regardless of the original
source of the timing.
To retrieve the settings from an RX:
1. From the Communications menu, select Retrieve Current Timing.
To save the settings in the utility to a file:
1.
From the File menu, select Save Timing to File.
To load the timings from a file to the utility and then apply them to an RX:
1. From the File menu, select Load Timing from file.
2.
Click Apply to transmit the loaded timing to the RX. This action is temporary (and you can still
cycle through the Scaling options) until the settings are stored on the RX in Step 4; otherwise, the
settings last only until power is cycled. The display re-syncs with the module.
3. Verify that the display is satisfactory before proceeding.
4.
Click Save* to store the currently displayed settings (if the setting have been changed since clicking
Apply, the newest settings will be saved) on the RX and persist them in memory. (The RX will
power up in the Manual option.)
* If you click Close instead of Save immediately after applying settings, the utility asks if you want to
save prior to exiting. Selecting Yes applies the settings, persists them on the RX, persists the Manual
mode on the RX over power cycles, and closes the utility. Selecting No closes the utility; the applied
settings are still in effect and can be accessed under the Manual option. However, they are not stored on
the RX and on power cycle, the RX will revert to its previously stored settings.