AMX AVB-RX-DGX-SC Fiber-DVI, Instruction Manual

Page: 27 / 79

Installation and Setup
23 DGX Transmitters & Receivers Instruction Manual
Installation and Setup
UL Safety Certifications, Notices, and Recommendations for Laser Products
Per UL requirements, make note of the following:

The DGX TX Fiber modules comply with IEC Standard: IEC 60825-1, 2001.

The modules also comply with 21 CFR 1040.10 and 1040.11 except for deviations pursuant
to Laser Notice No. 50, dated June 24, 2007.

The DGX TX Fiber modules are CLASS 1 LASER PRODUCTS.

The maximum output power of the laser radiation is 4.08 mW.
Since the class of radiation emitted from the fiber port can be Class 3R when the fiber cable or dust plug
is removed, a yellow and black label with the following caution is located on the top of each DGX TX
Fiber Module:
Safety Recommendations for Laser Products
Important:
There are no user serviceable parts inside AMX DGX SC Fiber products; service should
only be done by qualified personnel.
Caution:
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Exercise caution when installing DGX products to avoid direct eye exposure to invisible laser radiation.
Follow the recommendations below whenever installing or working with DGX products.
  Be sure to apply the power last, so that the fiber connector is not exposed when power is applied.
  Do not remove dust plugs from SC fiber connectors or the dust caps from the fiber cables until
establishing connections; avoid direct eye exposure.
  Make sure all cables, including fiber cables, are correctly connected and/or terminated.
  If you need to unplug the fiber cable, be sure to unplug the power on the TX first.
FIG. 11 Caution label for Class 3R laser products