Installation
5
8.5" Black and White Touch Panels
5.
Remove the BB-TP2 and drill holes (A and B) for the panel (FIG. 3). Then, place #6-32
threaded inserts into the four holes marked ‘B’ in the above cutout dimensions illustration.
6.
Disconnect the AXlink connector from the Central Controller. Then, disconnect the optional
RS-232 wiring from the external RS-232 device connected to the panel.
7.
Remove one or more knockouts to accommodate the wiring as required.
8.
Thread the incoming AXlink and RS-232 wiring through the knockouts. Refer to the
Wiring
the Touch Panel
section on page 8 for pinout descriptions.
9.
Fasten the BB-TP2 to the solid surface using the supplied mounting screws.
10.
Connect the AXlink and RS-232 wiring to the touch panel.
11.
Test the connection by reconnecting the AXlink connector to the Central Controller and the
optional RS-232 wiring to the source equipment. The panel beeps power-up. Before
continuing, disconnect all connections until panel installation is complete.
12.
Fasten the touch panel to the BB-TP2 using the #6-32 screws supplied with the panel.
13.
Place the Decor-style faceplate onto the bezel. You can also secure the faceplate to the bezel
using the four Phillips flathead security screws.
14.
Remove the backing from the adhesive tape strips on the touch panel; press the engraved
overlay onto the faceplate. Once attached to the faceplate, the security screws cannot be
replaced without removing the overlay.
FIG. 3
Decor style (AXD) and BB-TP2 cutout dimensions (solid surfaces)
